Home> Industry News> Analysis and improvement scheme of edge warping, edge cracking and edge delamination after polyurethane laminating adhesive is compounded

Analysis and improvement scheme of edge warping, edge cracking and edge delamination after polyurethane laminating adhesive is compounded

2026,09,29
In the dry lamination production of flexible packaging, edge warping, edge sealing cracking and local edge delamination are high-frequency corner defects. This defect mostly occurs after curing, cutting and bag-making processes, and the middle film surface is bonded normally, but the edge is tilted and glued, which not only increases the cutting loss, but also easily causes leakage and edge explosion at the bag-making edge sealing position, which directly affects the service performance of finished products and customer acceptance standards.
 
Edge coating and uneven stress are the core incentives. In the production process, in order to avoid glue overflow, the blank edge on one side is too wide, which leads to insufficient coating amount and thin adhesive layer on the edge of the film, and the adhesive force is much lower than that in the middle of the film surface. At the same time, the two ends of the anilox roller are slightly blocked and scraped unevenly, resulting in the lack of glue at the edge, insufficient adhesive strength after cross-linking and curing, and easy to become warped and delaminate under tension.
bags.33.
Process and equipment working conditions will aggravate the corner defects. The uneven pressure at both ends of the composite press roll and the weak edge pressure lead to the false adhesion of the interface; When the winding tension is too high and the edge of the coil is squeezed and pulled, the uncured adhesive layer is easy to separate. In addition, the air flow at the edge of the workshop is large, the solvent in the corners volatilizes too fast, and the adhesive layer dries up in advance, which makes the flexibility worse after curing and is easy to crack and delaminate after being stressed.
 
Targeted rectification can completely solve the corner defects. Adjust the width of coating blank reasonably, ensure the sufficient amount of glue on the edge, and regularly clean the clogged glue scales at both ends of the screen roller. Calibrate the pressure of compound roller to ensure the uniform stress on the whole film surface. Optimize winding tension, avoid excessive edge pulling, and stabilize workshop airflow and drying temperature. Through refined corner process control, the problems of edge warping, cracking and edge delamination are effectively eliminated, and the production loss is reduced.
Contact Us

Author:

Ms. Cherry

Phone/WhatsApp:

+86 13549820808

Popular Products
You may also like
Related Categories

Email to this supplier

Subject:
Mobile:
Email:
Message:

Your message must be between 20-8000 characters

Copyright © 2026 Guangdong Xinhui Chemical Co.,Ltd. All rights reserved. Privacy Policy

We will contact you immediately

Fill in more information so that we can get in touch with you faster

Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.

Send